Tools for
Woodwork

Lumber and materials / 004

Moisture content calculator

Find the equilibrium moisture content wood settles at from the temperature and relative humidity of the room it lives in.

01 / Shop conditions

Find the moisture content wood settles at

Read the conditions where the project will live, not where the shop sits today. A cheap indoor hygrometer is enough.

02 / Result

Equilibrium moisture content

7.7 %

What it means

Wood stored long enough in these conditions settles near 7.7 percent moisture content. Buy and acclimate lumber close to this number, then check it with a moisture meter before milling.

Wood settles where the room tells it to

Wood exchanges moisture with the air until it reaches equilibrium moisture content, the point where it is neither gaining nor losing water. Enter a temperature and relative humidity and the calculator applies the sorption equation published in the USDA FPL Wood Handbook (GTR-190, equation 4-5) to find that value for interior conditions.

Use the destination, not the shop

The number that matters is the room where the finished piece will live. A heated interior in winter can run under 30 percent humidity, which pulls furniture down toward 6 percent moisture content, while an unheated shop swings far wider. Acclimate lumber near the destination EMC and verify with a pin or pinless moisture meter before milling.

What the equation assumes

The published fit covers about 30 to 130 degrees F and up to 97 percent humidity, and applies to most species for practical purposes. Coatings slow moisture exchange but do not stop it, so seasonal swings still reach a finished piece. Feed the seasonal low and high into the wood movement calculator to see how far a panel actually travels.

Keep going