Tools for
Woodwork

Shop math / 002

Fraction converter

Convert tape-measure fractions, decimal inches and metric measurements in the workshop.

01 / Measurement

What is on your tape?

Try 1/2, 1 1/4, 2.375 or 63.5mm. No unit means inches.

02 / Converted measurement

Decimal inches

2.3750 in

Millimeters

60.32 mm

Nearest 1/16 inch

2 3/8 in

Reading a measurement

Enter a fraction such as 1/2, a mixed number such as 1 1/4, a hyphenated tape-measure reading such as 2-3/8, or a decimal such as 2.375. You can also add a unit (63.5mm, 2.5cm, 1ft). Values without a unit are treated as inches. The converter displays decimal inches, millimeters and the nearest sixteenth of an inch.

How the conversion works

One inch is exactly 25.4 millimeters. For a mixed number, divide the fraction's numerator by its denominator and add the whole number. For example, 2 3/8 inches is 2.375 inches, or 60.325 millimeters. The fractional readout rounds to the closest 1/16 inch, so use the decimal or metric output when you need greater precision.

Check before cutting

The fractional readout is a convenience for marking out stock, not a substitute for a drawing tolerance. A rounded sixteenth may be too coarse for joinery, hardware fitting or machine setup. If your drawing uses millimeters, keep the millimeter result through the whole layout rather than repeatedly converting and rounding.

Keep going