Tools for
Woodwork

Shop math / 003

Screw and pilot hole chart

Wood screw gauge chart with pilot hole, clearance hole and countersink sizes for hardwood and softwood.

01 / Screw

Pick the gauge and the wood

Hardwood needs a larger pilot hole than softwood for the same screw. Drill a test joint in scrap when splitting or stripping matters.

02 / Drill sizes

Pilot hole (softwood)
3/32 in
Clearance hole
11/64 in
Countersink diameter
0.38 in
Screw shank
0.164 in

The pilot hole clears the threads in the lower board; the clearance hole lets the shank slip in the upper board so the screw pulls the joint tight.

Three holes, one screw

A correctly driven wood screw uses up to three drill sizes. The clearance hole lets the shank slide through the top board, the pilot hole guides the threads into the bottom board without splitting it, and the countersink seats a flathead flush. Pick the screw gauge and whether the wood is hardwood or softwood and the chart returns all three sizes.

Hardwood wants a bigger pilot

Dense species grip threads so well that the screw can snap or split the board before it seats. The chart drills hardwood pilots one size larger than softwood pilots for the same screw. For a bolt or a lag screw, consult its own chart; these figures cover standard wood screw gauges from #2 through #14.

When in doubt, test

Charts are starting points, not guarantees. End grain, short distances to an edge and brittle species like cherry all raise the risk of splitting. Drill a test joint in a scrap of the same stock and check the screw seats snugly before committing to the project.

Keep going