Tools for
Woodwork

Cut and plan / 003

Cut-list planner

Arrange straight cuts across identical stock lengths with a kerf allowance and printable board-by-board plan. Check the suggested layout against your actual stock before cutting.

01 / Your stock

Enter your cuts

Lengths without a unit are inches. Enter one part per line, up to 100 parts.

02 / Layout estimate

2 boards

Best-fit layout, not a guaranteed minimum.

Stock board 1Offcut 7.63 in

32.00 + 32.00 + 24.00 in

Stock board 2Offcut 53.75 in

24.00 + 18.00 in

130.00 in parts + 0.63 in kerf. Total offcuts: 61.38 in.

Plan your straight cuts

Enter the length of one stock board and the width of your saw blade's cut. Put each finished part length on its own line. If you need three identical rails, enter that length three times. You can mix inches, fractions and explicitly marked metric dimensions. With no unit, values are inches. The plan groups parts onto stock boards and shows the remaining offcut after each group.

How the layout works

The planner sorts parts from longest to shortest, then places each one in the board that will have the smallest remaining space after the cut. This is a best-fit decreasing heuristic. It usually makes a useful starting layout, but it does not prove that the board count is the absolute minimum. Try alternate stock lengths or review the layout by hand if material is expensive.

The planner reserves one kerf for every part, even for a part that could fill a stock board exactly without a separating cut. This conservative rule can reject a part as long as the stock board. It does not account for end trimming, defects, grain direction, milling loss, clamping space, or a safety margin. Reduce the available stock length before entering it if you need to trim the ends. Never cut a piece based only on this plan without checking your actual boards and saw setup.

For example, two 32-inch parts and one 24-inch part fit on a 96-inch board with a 1/8-inch kerf per cut. The total occupied length is 32 + 32 + 24 + 3 x 1/8 = 88 3/8 inches, leaving 7 5/8 inches. If you need more parts, the planner opens a second stock board when the remaining space is too small.

Keep a workshop copy

Use Print for a paper copy or Download CSV for a spreadsheet-friendly list of boards, parts and offcuts. Share the URL if someone else needs to see the same inputs. The plan contains lengths, not a drawing; check the order and mark each board before cutting.

Keep going