Tools for
Woodwork

Cut and plan / 004

Sheet goods layout planner

Arrange rectangular parts across plywood, MDF or solid panels with kerf and rotation, then check the diagrams before cutting.

01 / Sheet and parts

Enter your sheet and parts

One part type per line: width x height x quantity. For example 24 x 18 x 4 for four 24 by 18 panels.

02 / Layout estimate

2 sheets

Best-fit packing, not a guaranteed minimum.

Sheet 1 · 5 parts

18.0 x 36.018.0 x 36.018.0 x 36.018.0 x 36.024.0 x 24.0

Sheet 2 · 5 parts

24.0 x 24.012.0 x 24.012.0 x 24.012.0 x 24.012.0 x 24.0

10 parts. Sheet area used: 53.1% before kerf loss.

Plan sheet goods

Enter your sheet size, your saw kerf, and each finished part size with its quantity. A line reads width x height x quantity, so 24 x 18 x 4 means four finished panels 24 inches wide and 18 inches high. Allow rotation when the grain direction or the part's appearance does not force an orientation; uncheck it when panels must keep their length in one direction. The diagram shows where each part lands on each sheet.

How the layout works

The planner places the largest part first. Each part is packed into the open rectangle where it leaves the least space on its shorter side, using a best-fit free-rectangle heuristic. When a part cannot fit on any open sheet, a new sheet is started. This method quickly produces a workable layout, but it does not prove the fewest possible sheets. If material is expensive, try a different part order or consider alternate stock sizes before cutting.

The planner adds one kerf to each part's width and height before packing. This is a conservative approximation of real cuts; your actual cutting sequence may recover slightly more material, or lose slightly more if you trim sheet edges. It does not model panel defects, edge banding, grain matching across adjacent parts, or rip cuts that must happen before crosscuts. Square the sheet and check for shipping damage before trusting the corners as reference edges.

Reading the diagram

Each rectangle is drawn at its packed position including the kerf allowance, and labeled with the finished size. Parts with the same size may appear on different sheets depending on how space remains. The "sheet area used" figure compares raw part area to total sheet area before kerf loss, so it will always read a little lower than what the saw actually removes.

Download the CSV for a cut-by-cut coordinate list, print the page for the bench, or share the URL to reproduce the same layout. Re-run the plan any time a part dimension changes. If you only need straight rip cuts from solid stock rather than two-dimensional panels, the cut-list planner is the simpler tool.

Keep going