Tools for
Woodwork

Shop math / 005

Dust collection sizing

Duct diameter to CFM at the standard 4000 FPM transport velocity, plus typical machine demand figures.

01 / Duct

What can this duct move

Common ports are 2.5 in on small tools, 4 in on saws and jointers, and 5 or 6 in on planers and main trunks.

Typical machine demand

Table saw4 in350 CFM
Jointer4 in350 CFM
Planer4 in400 CFM
Bandsaw4 in350 CFM
Miter saw2.5 in300 CFM
Router table2.5 in195 CFM
Drum sander4 in600 CFM
Disc sander5 in550 CFM

Approximate minimums at the port; published figures vary by source and hood design.

02 / Capacity

CFM at 4000 FPM

349 CFM

Duct area

12.6 sq in

4000 feet per minute is the transport velocity that keeps chips moving in horizontal runs. Flexible hose and tight bends cost real capacity, so treat this as the ceiling the duct allows, not what the collector delivers.

Air speed moves the chips, not just the air

Dust collection works when air moves fast enough through the duct to keep chips suspended: about 4000 feet per minute in horizontal runs. CFM capacity is duct area times that velocity, which is why a 4 in duct tops out near 350 CFM no matter how large the collector is. Enter a duct or port diameter and the calculator returns the CFM it can carry.

The machine table is a starting point

The reference table lists approximate minimum CFM demand for common machines at their factory port sizes. Published figures differ between sources because hoods, gates and pickup design change the real requirement; machines that throw chips, like planers and drum sanders, want more than saws that drop dust politely.

Duct losses are real

Every foot of flexible hose, every 90 degree elbow and every blast gate eats static pressure and capacity. The computed CFM is the ceiling the duct allows at transport velocity, not what the collector delivers at the tool. Runs with many bends belong to a static pressure worksheet, which this tool does not model.

Keep going