Tools for
Woodwork

Guides

How to plan a cut list before buying lumber

Turn project dimensions into a workable cut list, account for kerf and defects, and check the plan against real stock.

A cut list turns a drawing into parts you can actually make. List the finished length, width, thickness and quantity of each part first, then compare those parts with real stock. Include saw kerf, end trimming, defects and grain selection before deciding how many boards to buy. A cutting layout is a starting plan, not permission to cut without marking.

Start with finished dimensions

Write down every part from the drawing, including duplicate rails, shelves and stretchers. Give each a clear name. Record whether its dimension is a finished size or the rough blank you need to mill it. A part that finishes at one thickness may require thicker rough stock; the extra depends on how much your own boards need to be flattened. Do not copy the nominal size of a purchased board into the finished-size column without checking it.

Mark which parts need their grain to run in a particular direction. A long rail cannot simply be rotated to fit a short offcut if doing so puts its grain across the span. Visible parts may also need color or grain matching. Those choices constrain the layout before an optimizer sees the numbers.

Check the boards you can actually buy

Measure the usable length and width of each board. Mark splits at the ends, knots you cannot use, and any twist or cup that will cost material during milling. A board with the right nominal dimensions may still have too little clear stock for a particular part. If you need a continuous, clear 48-inch rail, two 24-inch offcuts will not substitute for it.

Keep rough lumber volume and part lengths as separate questions. Board feet estimate the volume you are purchasing; they do not tell you whether the parts will fit. A length layout tells you which straight cuts may fit, but not whether you have enough width or thickness. For sheet goods, panel rotation, grain face and cutting sequence require a different two-dimensional plan.

Add the cut losses

Every saw cut removes a strip of material called the kerf. Measure or verify the kerf of the blade you intend to use instead of assuming all blades remove the same amount. When planning several parts from a single stick, reserve kerf between parts and allow space to square damaged ends. If a final part is exactly the board length, you may need extra length to trim an end cleanly.

The cut-list planner groups one-dimensional lengths across identical stock boards. Enter each part once for every copy needed. It reserves one kerf per part, a conservative rule that may leave a small extra allowance. It does not account for width, defects or machine setup. Review each suggested board in the shop and adjust the plan before making the first cut.

Choose a cutting order

Start with the longest and hardest-to-replace pieces. Rough-cut them with enough extra length for final squaring, then keep paired parts together. Short pieces are often easier to recover from offcuts later. Label each rough part as soon as it is cut, particularly when several parts differ by only a fraction of an inch.

Before final dimensioning, check the assembly method. Joinery may change the length of a blank or the location of a shoulder. Decide whether a dimension in the drawing runs to the outside of a frame, to the end of a tenon, or to a finished edge. If the drawing is ambiguous, resolve that before ordering stock or cutting a full batch.

Review the plan at the bench

Print the layout or save its CSV alongside your project drawing. Compare the planned pieces with each physical board, marking the chosen face and the intended cuts. Recalculate when you change a board length or a part dimension. If the layout depends on a very small offcut, allow more room or buy another board rather than betting the project on a perfect cut.

A useful cut list is revised as the project becomes real. Keep track of which parts are finished, which are still rough, and which boards still have usable offcuts. That small habit prevents buying material twice and makes the next build easier to estimate.

Keep going