Sheet goods cover most of what solid lumber does not do well: wide panels, flat stable surfaces and casework that must stay square. Picking the right one starts with knowing what each panel is actually made of and what it can take.
The main types
Plywood is thin wood veneers glued in alternating grain directions. The cross-banded structure makes it strong, stable and resistant to splitting, which is why it dominates casework, shelving and drawer bottoms. Face grades run from A (clear, sanded) down to D (patchy utility), and the core matters as much as the face: veneer-core is light and stiff, MDF-core is flatter for finishing.
MDF is wood fiber pressed with resin into a dense, uniform panel. It has no grain direction, machines to a glassy edge and takes paint beautifully, which is why it suits painted cabinets, jigs and templates. It is heavy, swells badly if wet and does not hold screws in the edge well.
OSB is oriented strands pressed into a structural panel. It is cheap and strong for sheathing, shop floors and utility work, but the rough face and edge make it unsuitable for finished work.
Particleboard sits near MDF but is coarser and weaker, mostly used where cost beats performance.
Choosing for the job
Match the panel to the demand. For shelving that must resist sag, plywood beats MDF of the same thickness; use the shelf sag calculator to compare. For a painted box or flat jig surface, MDF is flatter and cheaper. For structural or weather-exposed work, exterior-grade plywood or OSB rated for the exposure is the choice, since standard panels delaminate when wet.
Thickness is rarely the label. A 3/4 inch sanded plywood panel is really 23/32 inch, and that gap changes dado widths and edge-band reveals. Measure the actual panel before cutting joinery; the nominal dimensions reference lists the standard real thicknesses.
Planning the layout
Sheets are expensive and cuts are irreversible, so lay out the cut list on the panel before sawing. Group parts by thickness so each sheet cuts one material, orient grain-dependent parts (like door faces) consistently and leave room for the blade kerf between parts. The sheet goods layout planner packs your part list onto sheets and shows where each piece lands, which beats sketching on a napkin for anything beyond two or three parts.
Edge treatment matters too. Plywood edges show veneer layers and need banding or a face frame for finished work, while MDF edges take edge-banding or a routed profile cleanly. Plan the edge treatment into part dimensions, not as an afterthought.
Common mistakes
- Buying MDF for a shelf that needs stiffness; it sags where plywood holds.
- Assuming a 3/4 inch panel is really 3/4 inch thick.
- Cutting sheet goods without a layout, then running out of panel for the last part.
- Using interior panels where moisture will reach them.