Veneer is bought by the square foot
Veneer sells by face area, so the order quantity is panel area times faces plus waste. Enter the panel width and height, one face or two, and a waste allowance; fifteen percent covers trimming the overhang and basic grain matching. Sequence-matched or book-matched work can need more because the usable leaf layout is constrained.
Banding is bought by the lineal foot
Edge banding sells by lineal feet on rolls. List each edge as length times count, one per line, and the calculator totals the footage plus a trim allowance for cutting flush at the ends and the occasional recut. Iron-on banding commonly comes in 25 foot rolls.
Order oversize, always
Both materials need overhang to trim: veneer is cut an inch or more past the substrate edge, banding a couple of inches past each end. Buying exactly the computed footage leaves nothing for mistakes. For the plywood cuts underneath, the sheet layout planner arranges the panels first.