Tools for
Woodwork

Glossary

Janka hardness

What the Janka hardness test measures, what the number does and does not tell you, and typical values for common species.

Janka hardness is a standardized measure of a wood species' resistance to denting. The test records the force required to press a 0.444 inch steel ball halfway into a sample of wood. Results are reported in pounds-force in North America, with higher numbers meaning harder wood.

What the number means

Janka measures one specific kind of resistance: indentation near the surface. It is widely used to compare species for flooring and workbench tops because it predicts how the wood handles dropped tools, chair legs and daily abrasion. It does not measure strength in bending, stiffness or splitting resistance. Those are different properties with different tests.

Species values published in references such as the USDA Wood Handbook are averages from tested samples. Individual boards vary with density, growth rate and grain direction, so a test result describes the species, not the exact board in your hand.

Why it matters

Hardness shapes several shop decisions. Harder species resist denting and hold crisp edges, which suits cutting boards, floors and hammered joinery. They also demand more from edge tools, feed more slowly through planers and can burn during routing. Softer species shape and sand quickly but pick up handling marks.

Janka also hints at wear on cutting edges and sanding progression, but it is only one input. Silica content, grain interlock and extractives matter as much to tool wear.

Common confusion

  • Janka is not a durability rating for outdoor use. Decay resistance is a separate property.
  • A higher Janka number does not mean a stiffer board. Stiffness is the modulus of elasticity, a different test.
  • End grain tests harder than side grain, so published side-grain values are the comparable figures.

Related tools

Browse species hardness figures in the wood library, or use the shelf sag calculator when the question is stiffness rather than dent resistance.

Keep going