Dado is a flat-bottomed, square-sided channel cut across the grain of a board. A dado runs across the grain; the same channel cut with the grain is a groove, and the same channel at a board's edge is a rabbet. The three cuts are the same geometry in different positions.
What it means
Dados are cut with a stack of blades (a dado set) on a table saw, or with a router and a straightedge or jig. Depth typically runs about one-third of the material's thickness so the shelf or divider seats firmly without weakening the side. A groove follows the same profile but along the grain, commonly for panel bottoms in frame-and-panel work. A rabbet sits at the edge or end of a board, used for back panels, lap joints and case assembly.
Width matters more than depth for fit. Plywood and sheet goods rarely measure their nominal thickness, so a dado for a shelf must be sized to the actual panel, not the label.
Why it matters
Dados and grooves give casework its structure. A shelf seated in a dado is supported mechanically, not just by fasteners, so it resists sagging and the case stays square. Rabbets on case backs hide the panel edge and add racking resistance. Together they are the basic joinery of bookcases, cabinets and drawers.
Cut them with the grain orientation in mind: a dado across plywood veneer can tear out without a scoring pass or sharp, clean setup.
Common confusion
- Dado is across the grain, groove is with the grain, rabbet is at the edge. Same channel, different location.
- Measure the actual panel thickness for the dado; 3/4 inch ply is really 23/32.
- A dado cut too deep weakens the side more than the shelf gains.
Related tools
Panel layout for dadoed casework starts with the sheet goods planner, and actual plywood thicknesses are in the nominal dimensions reference.