Tools for
Woodwork

Glossary

Dovetail

What a dovetail joint is, how the interlocking tails and pins resist pull-out and where the joint earns its place.

Dovetail is a mechanical joint made of flared, wedge-shaped tails on one board that interlock with matching pins on the mating board. The flared geometry means the joint cannot pull apart in one direction even without glue, which is why it has marked quality casework and drawers for centuries.

What it means

In a through dovetail, both tails and pins show on both faces and the joint is fully visible from outside. In a half-blind dovetail, the tails hide inside the drawer front so the joint disappears when the drawer is closed; this is the standard for drawer construction. Sliding dovetails run a single long tail into a matching groove, used for attaching shelves and dividers.

The angle of the flare matters. Steeper slopes look refined but create weak short-grain tips that can snap; shallower slopes cut safer for hardwoods. Spacing decides how the joint reads visually and how much wood is left between sockets.

Why it matters

Drawers are the classic case: every pull tries to separate the front from the sides, exactly the direction a dovetail refuses to move. The joint's strength comes from geometry, not just glue, so it survives decades of seasonal movement and use. Hand-cut dovetails also carry craft value as a visible sign of skill.

The trade-off is complexity. Dovetails demand accurate layout, sharp tools and patient fitting, or a dedicated jig and router setup.

Common confusion

  • Tails go on the drawer sides, pins on the front and back, so the mechanical lock works against the pull direction.
  • A dovetail is not primarily a glue joint; it holds mechanically before the glue cures.
  • Box joints look similar but are square fingers, not tapered, and resist pull in both directions.

Related tools

Lay out tail and pin spacing for a given board width with the dovetail spacing calculator.

Keep going