Kerf is the width of material removed by a saw cut. It is not the thickness of the finished part or the distance between two pencil marks. Kerf depends on the blade and the cut, so measure or verify the setup you will actually use before planning a tight sequence of parts.
What it means
When you cut a board, the teeth remove a strip of wood. That strip becomes sawdust, leaving the cut edges on either side. The gap is the kerf. Blade plate thickness alone may not tell you the full kerf because teeth can project beyond the plate. Different blades, bandsaw settings and cutting methods can produce different gaps.
For a single crosscut at a line, decide which side of the line belongs to the finished part. Placing the blade on the wrong side can shorten it by about a kerf. For a set of repeated parts, even a small amount of loss per cut adds up across the stock length. Use a stop or a clearly marked layout when repeatability matters.
Why it matters in the shop
Suppose you need three pieces that each finish at 30 inches from a 96-inch board. The parts occupy 90 inches before any cuts. Each cut removes additional material; if the ends also need squaring, allow for those cuts as well. You cannot assume that an offcut's full measured length will be available as a finished part.
Saw kerf also matters when designing closely spaced joints and repeated slats. A layout that looks balanced on paper may lose too much material once actual cuts are made. Test the operation on scrap when the remaining clearance is small, and measure the resulting slot rather than relying on the blade packaging.
Common confusion
Kerf is a cut width, not a universal number. It should not be confused with stock thickness, the width of a pencil line, or an allowance for defects. A cut-list estimate can reserve kerf for every part, but you still need a separate allowance for trimming ends, milling irregular boards and avoiding damaged areas.
Use the cut-list planner to see how a kerf allowance affects a straight-cut layout. If you are estimating the amount of lumber to purchase by volume, use the board foot calculator as a separate check.