Tools for
Woodwork

Glossary

Mortise and tenon

How the mortise and tenon joint works, its variations and where it belongs in furniture and framing.

Mortise and tenon is a joint in which a projecting tongue on one piece fits into a matching cavity in another. The tongue is the tenon, the cavity is the mortise, and glue or pegs lock the two together. It is one of the oldest and strongest ways to join wood at a right angle.

What it means

A tenon is formed by cutting shoulders on all four sides of a board's end, leaving a centered tongue. The mortise is a rectangular hole chopped, drilled or routed into the mating piece. The fit should be snug enough to hold its shape dry but not so tight that assembly needs a hammer. Glue area on the tenon's cheeks does the structural work, which is why the joint handles racking loads that defeat simpler joints.

Variations cover most needs: through tenons pass fully through and can be pegged or wedged; stub tenons stop short inside the mortise; haunched tenons fill a groove at the corner; loose or floating tenons use a separate strip mortised into both pieces.

Why it matters

Frame-and-panel doors, chair and table legs, workbench bases and timber framing all rely on mortise and tenon because it resists the twisting and racking forces that loosen screws and nails. The joint also end-grains correctly: the tenon's long grain glues to the mortise's long-grain walls, a strong bond, unlike end-to-face joints that glue weakly.

Layout accuracy decides the joint. The mortise and tenon must share a common reference face or the frame racks out of square.

Common confusion

  • The tenon goes on the piece being joined, typically the rail, not the post or stile.
  • A through tenon is not inherently stronger than a stub tenon; glue surface does the work.
  • Loose tenon joinery (a floating strip in two mortises) is a legitimate variation, not a shortcut imitation.

Related tools

Size the surrounding parts with the cut-list planner, and check frame angles for angled joinery with the frame miter calculator.

Keep going