Tools for
Woodwork

Joinery and geometry / 004

Box joint calculator

Divide a board into an even number of interlocking fingers for a box joint, with the exact finger width and cut lines.

01 / Layout

Divide a board into even fingers

The count snaps to an even number so both boards start and end the same way. The actual finger width adjusts slightly to divide the board exactly; set your jig or dado key to that value.

02 / Layout

Actual finger width

1/4 in

0.2500 in

Fingers per board

12 of 24 spaces

Cut every other space on the first board, then flip or offset the mating board by one finger so the fingers interlock.

Even fingers, no leftover sliver

Box joints need the board divided into an even number of identical spaces, half fingers and half slots. Enter the board width and a target finger width, usually the dado stack or router bit you plan to use, and the calculator snaps the count to an even number and returns the exact finger width.

Why even counts

An even count puts a finger at both edges of one board and a slot at both edges of its mate, which is what makes the joint interlock. The actual finger width shifts slightly from the target so the spaces divide the board exactly; set the jig key to the actual width, not the target.

Cut strategy

Cut the first board against the key, then offset the mating board by one finger so the pattern flips. Sneak up on the fit with a test piece; fingers that are a thousandth fat still fight assembly. For angled joinery with the same careful layout, see the dovetail spacing calculator.

Keep going