Tools for
Woodwork

Joinery and geometry / 002

Segmented ring calculator

Lay out segmented turning rings with the miter angle per segment and the outside edge length for a given ring diameter.

01 / Ring

Lay out a segmented ring

Diameter is measured point to point across the outside of the finished ring. Cut segments slightly long and sand the ring round on the lathe.

02 / Cut plan

Miter each end at

15.00 deg

Outside edge per segment

2.588 in

12 segments lose 1.50 in to the blade across the ring. Add cutting allowance before trimming.

Rings built from straight pieces

Segmented turning builds bowls and vessels from rings of identical trapezoids. Each segment is mitered at 180 divided by the segment count: twelve segments at 15 degrees, sixteen at 11.25. Enter the count and the finished outside diameter and the calculator returns the cutting angle and the outside edge length of each segment.

Cut long, true on the lathe

The math gives a theoretical edge length, but glue lines and saw wander eat the diameter. Cut each segment a sixteenth long, glue the ring, and turn it round on the lathe; the outside edge length tells you the minimum stock width, not the exact cut size.

Kerf loss adds up

With many segments the blade kerf removes real material around the ring. The result shows total kerf loss across the ring so you can see why sixteen segments need more allowance than eight. For flat-sided boxes with the same angle math, see the frame miter calculator.

Keep going