Tools for
Woodwork

Joinery and geometry / 001

Compound miter calculator

Find the miter and bevel settings to cut crown molding and other compound joints flat on a miter saw.

01 / Angles

Set the saw for crown molding

The spring angle is how far the crown tips off the wall, often 38 or 45 degrees and usually printed on the packaging. Measure odd wall corners with an angle finder.

02 / Saw settings

Miter (table rotation)

35.26 deg

Bevel (blade tilt)

30.00 deg

Cut the crown lying flat on the saw bed. For an inside corner, tilt the blade and swing the table the same direction; outside corners mirror the settings.

Two angles, one cut

Crown molding sits tilted between the wall and ceiling, so a plain 45 degree miter will not close the joint. Cut flat on the saw bed, the piece needs both a table rotation (miter) and a blade tilt (bevel). Enter the wall corner angle and the crown spring angle, usually 38 or 45 degrees, and the calculator returns both settings.

The spring angle matters most

Two pieces of crown can share a profile but spring at different angles, and they cut completely differently. The spring angle is how far the face tips away from the wall; it is printed on the packaging or measurable by laying the crown against a framing square. Standard cove crown springs at 45 degrees; most 38 and 52 degree crown springs at 38.

Inside and outside corners

The settings are the same for inside and outside corners; only the orientation flips. Keep the crown flat on the bed, rotate the table and tilt the blade in the same direction, and cut a test joint in scrap first. For flat polygon frames with no bevel, the frame miter calculator is the right tool.

Keep going