Tools for
Woodwork

Joinery and geometry / 009

Drawer and door sizing

Size overlay or inset cabinet doors and drawer boxes from the opening, the gap or overlay, and slide clearance.

01 / Opening

Size doors and drawer boxes

Full overlay doors usually cover the opening by 1/2 in per side. Inset work commonly uses a 1/16 in gap all around. Drawer box width is the opening minus both slide clearances; height leaves 3/4 in of running room.

02 / Sizes

Door

16 x 21 in

16.000 x 21.000 in

Drawer box for the same opening

14 x 19 1/4 in

Width x height. Depth is set by the cabinet, not the opening; leave an inch or so behind the box.

Everything sizes from the opening

Cabinet fronts are derived, not guessed. Overlay doors cover the opening plus the overlay amount on every side; inset doors fit inside it minus a small gap, commonly 1/16 in. Enter the style, the opening, the margin and whether the opening takes a single door or a pair and the calculator returns each door's size plus a drawer box for the same opening.

Pairs share a center reveal

Two doors meeting in the middle need a gap so they do not strike each other; the calculator splits the width evenly around the center reveal. Inset pairs use the same gap as the perimeter, overlay pairs a typical 1/8 in.

Drawer boxes follow the slides

Box width is the opening minus the clearance each slide needs, commonly 1/2 in per side for standard ball-bearing slides; undermounts and side mounts differ, so check the slide spec sheet. Box height leaves about 3/4 in of running room. Depth follows the cabinet, not the opening.

Keep going