Tools for
Woodwork

Joinery and geometry / 008

Taper and jig angle calculator

Find the angle and jig offset for a tapered leg or edge from the start width, end width and taper length.

01 / Taper

Find the taper angle and jig offset

A classic table leg tapers on two adjacent or opposite faces. For two faces each face carries half the total drop; for one face it carries all of it.

02 / Angles

Angle per face

1.79 deg

Total drop / jig offset

1.000 in

Set the taper jig fence so the cut line starts the offset distance from the reference edge, or mark the foot width and align the jig to the layout line.

Legs taper on layout, not on memory

A taper removes a fixed amount of width over a fixed length. Enter the width at the top, the width at the foot and the length of the taper and the calculator returns the angle each face leans and the jig offset, the distance to set the taper jig fence from the cut line.

One face or two

Tapering two opposite faces splits the drop between them, so each face leans at half the angle of a single-face taper. Many shaker legs taper the two inside faces only, keeping the outside faces square against the apron.

Lay it out anyway

Angles this shallow, often under two degrees, are easier to set by marking than by dialing the saw. Mark the foot width on the end of the stock, clamp the taper jig to the layout line, and test on a scrap of the same length.

Keep going