The bench should fit the work, not the catalog
Bench height depends on what you do at it. Hand planing wants a low bench so body weight sits over the plane, general assembly wants mid-height, and carving or close detail wants the work up near the eyes. Enter your height and pick the main work type; the calculator applies common shop rules of thumb and returns a height plus a comfortable range.
Rules of thumb, not law
The factors are approximations of familiar guidance: knuckle height for planing, hip height for general work, elbow height for detail. Body proportions vary, and shop shoes, anti-fatigue mats and stool habits shift the right answer by an inch or two. The result is a starting point to mock up with a temporary surface before building.
Taller is easier to fake
A slightly low bench is fixable with a thicker top or a riser under the legs; a too-tall bench is permanent discomfort. When the work is genuinely mixed, many shops split the difference with the general-work figure and add a raised platform for detail sessions. Mock it up first.