Spring angle is the angle at which crown molding is tilted away from the wall when installed, measured between the molding's back face and the wall. It is the fixed tilt the molding sits at in the corner, and it is what makes crown cuts compound rather than simple miters.
What it means
Crown molding is milled so its back has two flat edges that rest against the wall and ceiling. Because it is tilted rather than flat against either surface, cutting it for a corner needs both a miter and a bevel. The spring angle is the tilt built into the molding: common values are 38, 45 and 52 degrees, but the molding's actual tilt depends on its profile, not just its name.
Two crowns with the same nominal size can have different spring angles, which is why a saw setting for one molding will not fit another without checking. The spring angle, not the wall corner alone, drives the compound cut.
Why it matters
A compound miter that ignores the spring angle produces a joint that opens or binds. The miter angle rotates with both the corner angle and the spring angle, so a 90 degree corner with a 45 degree spring is a very different cut from the same corner with a 38 degree spring. Measuring the actual molding's tilt, not the number on the package, is the reliable starting point.
The angle also changes how the crown reads in the room, since a higher spring angle projects the profile farther from the wall.
Common confusion
- Spring angle is a property of the molding, not the room. A room's corner angle is separate.
- 38 degree crown and 45 degree crown need different saw settings in the same corner.
- Cutting crown flat on the saw needs the compound setting; cutting it nested uses a simple miter at a different angle.
Related tools
Get the correct miter and bevel for any corner and spring angle with the compound miter calculator.