Every number on this site comes from a named source or is labeled as an approximation. This page explains where the data comes from, how it is used and where the limits are, so you can judge the figures the way you would judge any workshop reference.
Wood species data
Species figures in the wood library come primarily from the USDA Forest Products Laboratory Wood Handbook: Wood as an Engineering Material (General Technical Report FPL-GTR-190). The handbook is the standard public reference for North American wood properties, compiled from laboratory testing.
The figures we use are species averages:
- Janka hardness, a measure of dent resistance in pounds-force.
- Specific gravity, the density relative to water, used for weight estimates.
- Radial and tangential shrinkage, the percentage change from green to oven-dry, used for movement estimates.
- Modulus of elasticity, stiffness in bending, used for shelf sag estimates.
Real boards vary. Density, growth rate and grain all shift the numbers, so treat published values as expectations for the species, not guarantees for the board in your hand.
Moisture and movement formulas
The moisture content calculator uses the equilibrium moisture content relationship fitted to the Hailwood-Horrobin sorption model, published in the Wood Handbook as equation 4-5 with the Simpson two-hydrate coefficients. The same handbook's Table 4-2 provides the reference values we validate against.
The wood movement calculator applies the handbook's standard approximation: shrinkage and swelling are treated as roughly linear with moisture content below the fiber saturation point, around 30 percent. This is a useful estimate for design, not a precise prediction for an individual board.
Material and product values
Some values are typical figures rather than tested data, and the calculators label them as such:
- Finish coverage rates are typical label values, not per-product specifications. Always use the rate printed on your product.
- Glue spread rates and clamp times are common reference ranges for each adhesive type. The manufacturer's instructions win.
- Engineered material stiffness values for plywood, MDF and particleboard are typical figures, not per-product test results.
- Lumber cost tiers are qualitative groupings (economy, standard, premium, specialty), not live prices.
Nominal and dressed dimensions
Softwood actual dimensions follow the standard North American dressed-dimension convention: nominal sizes under 8 inches lose 1/2 inch when surfaced, sizes at 8 inches and up lose 3/4 inch. Sanded plywood thicknesses use the common fractional standards (23/32 for 3/4 inch and so on).
What we do not claim
- Calculators estimate; they do not replace checking local building code, product labels or your own measurements.
- No values are invented. Where a reliable figure does not exist, we say so rather than guessing.
- Sources are cited at the document level (the Wood Handbook and related references), not quoted line by line.
If you find a figure that looks wrong, treat your own source as authoritative and let us know.