Rise and run describe the vertical and horizontal parts of any sloped layout. Rise is the vertical change; run is the horizontal distance over which it happens. Stairs, roof rafters, ramps and tapered parts are all laid out by pairing a rise with a run.
What it means
On stairs, rise is each step's height and run is the depth of each tread. The total rise is the floor-to-floor height; the total run is the horizontal distance the staircase travels. Building codes cap riser height and set minimum tread depth because extreme proportions are unsafe and uncomfortable. Roof pitch uses the same pair, conventionally expressed as rise per 12 inches of run.
The ratio sets the angle. A taller rise over a shorter run is a steeper slope; a smaller rise over a longer run is gentler. Layout tools like a framing square are built around transferring a chosen rise and run to the workpiece.
Why it matters
Comfort and safety follow the proportion, not the total height. Two stairs covering the same floor-to-floor rise feel very different if one uses shallow risers and deep treads while the other uses tall risers and narrow treads. The classic comfort rule, twice the riser plus the tread landing near 24 to 25 inches, is a check on that proportion.
Getting the individual dimensions starts by dividing the total rise into a whole number of equal risers, since the bottom step cannot be a different height without tripping people.
Common confusion
- Rise is measured to the top of the next tread, not to the top of the structure.
- Total run is the sum of the tread depths; it is not the stringer length, which is the hypotenuse.
- Roof pitch and stair slope use the same words but different conventions for expressing them.
Related tools
Work out risers, treads and stringer length with the stair stringer calculator, and find jig angles with the taper angle calculator.